Freenove Camera Mount

The stock camera mount is camera only with a seperate mount for ultrasonic sensor.

Also it is very wobbly, terrible design as also puts a lot of strain on 9g servos.

I replaced them with metal gear servos as a pair on Amazon very low cost.

The original design was a good start but the 9g servos I used did not fit well.

I also opened up the holes to allow a lot of M3 to be used as I have parts.

The base plate also mounts the buzzer and LED from the kit.

The kit is a good start but mechanical quality is poor so probably going to replace the steering and front assembly next.

I printed in PLA, Creality original at 200C bed 60C.

I´m using a E3D so fast printing.

I enabled support as the camera plate, including ultrasonic board, has standoffs.

the top clip is just there to tidy the wiring from the servos and camera.

Enjoy!