Airsoft VSR-10 Magazine / Speed Loader Holder

I wanted a 3D printed holder for my VSR-10 magazines since I was previously just letting them sit loose in an admin pouch on my belt. I looked at and printed other designs for holding them online but found them to not fit my needs. I wanted the magazine holder originally to replace the pouch but ended up with a design that can be added to the inside of the pouch which can help to make sure I don’t loose the magazine on the field.

I also found out that a standard 120rd speed loader has the same width as VSR-10 magazines which allows the holder to also function for holding the speed loader.

As for printing the parts themselves, for each “VSR-10 Mag Holder Part 1” you also need to print a “VSR-10 Mag Holder Part 2”. The second part may require some filing to get it to fit in the slot on part 1. I also included the spacer that I designed to go along with the set up. I added a rubber band to each of the cells individually and the spacer allows some room for the rubber bands to fit.

The admin pouch that I use can be found here: https://www.amazon.co.uk/Valtcan-Tactical-Military-Pouches-Napkins/dp/B07G8QRC64

(I am not sure if the pouch I use has been discontinued but any pouch that is similar should be able to be adapted in a similar way).

The pouch dimensions are 6in x 4in x 2in.

I attached the holder to the inside of the pouch using velcro to allow it to be removed should a cell break and need to be replaced.