This is a case for the awesome Portapack H2.

The Portapack from ShareBrained is an add-on for the HackRF. The HackRF from Great Scott Gadgets is a Software Defined Radio peripheral capable of transmission or reception of radio signals from 1 MHz to 6 GHz.

#Parts

* HackRF+Portapack H2+battery (clone):

https://s.click.aliexpress.com/e/_dSMPvNo

Screws (M2.8x10mm and M2.8x8mm):

https://s.click.aliexpress.com/e/_dSS6UAQ
[optional] 3d printing pen (to fill the led holes with translucent material):

https://s.click.aliexpress.com/e/_dUZEpXk

Extras

For the speaker I used one from an old lenovo laptop. Connect the yellow and red wires to the speaker and leave the black wire floating (from the H2 kit). The speaker was attached with thick foamy double sided tape under the left side of the LCD.
The battery was attached with thin double sided tape, in the middle of the 3 sets of pins of the Portapack pcb

#Video

https://www.youtube.com/watch?v=9VhhOtr-MG8

Speaker test: https://www.youtube.com/watch?v=XkaGV9muvbg

#Related
links

* Get the genuine HackRF: https://greatscottgadgets.com/hackrf/one/

* Get the genuine PortaPack H1 (not compatible with this case): https://www.sharebrained.com/portapack/

* Custom firmware: https://github.com/eried/portapack-mayhem

#Changelog

* 2020-04-06: Updated up and down pieces for better fit between them, nicer alignment with the status leds and micro sd card

2020-04-11: Updated down piece with extra slots for pins in the hackrf and stronger middle piece between the two CLK SMA and up piece with small tweaks

This article was first featured at https://cults3d.com/en/3d-model/tool/hackrf-portapack-h2-case on July 14, 2020 at 08:31AM by