3D relief map Madeira – October 24, 2022 at 01:19PM

0

0

The file is for a relief map of Madeira Island, which belongs to Portugal.

The relief card was printed with the Creality CR 30 Printmill. The wall thickness was set to 2 mm, but this was not enough everywhere. There are still small gaps in the very deep valleys. A wall thickness of 3 mm would be better. The material I used was PLA with wood content from OWL-Sat. When printed, you can also use it for table lighting, which could illuminate from the bottom with LED. Of course, you can also color them.

John Jason Fallows

See author's posts