Apple Watch Charging Dock

Minimal Apple Watch Charging Dock

Easy to print and easy to assemble. Works with all Apple Watch models and sizes. Works with both the USB-A and USB-C cables.

Instructions:

1. Print all the parts as shown in the components image, with support at 0.15mm or smaller.
2. Place the charging puck into the (Top Front) part, then snap the back on.
3. Thread the USB cable through the (Base Top) part and then snap shut with the (Base Bottom) part.
4. Place the (Centre half back and front) components into the base, then firmly press the assembled top part in (Aligning the rear with the wire, it’s hard to explain through text but basically the components should all align so that the wire follows through and out the back)

All done! Please be aware that due to 3D printing tolerances, the components may be really easy or hard to snap together, if it’s difficult, just print another!