Ikea Table Leg Extension

0

0

This is an Ikea table leg extension intended to extend an inexpensive Ikea table 4 inches (100mm). The end result after printing and using 4 of these 3d prints to extend an Ikea table height is a space beneath the table that is 1.5 inches taller than a Creality Ender 3 Pro without the filament holder attached.

I printed this at 100 mm/s with the starting layer beginning at 20 mm/s and 20% cubic infill using an Ender 3 Pro.

This design was influenced by Koganei “Ikea LACK Table Extension Stacker”. I did not want the ears that are present on his design as I opted to screw directly into the top of the supporting table. Also, I wanted a shorter leg that would print more quickly. Printing time using the settings above was just under 5 hours. for each support.

This article was first featured at https://cults3d.com/en/3d-model/tool/ikea-table-leg-extension on August 3, 2020 at 07:22AM by

John Jason Fallows

See author's posts