Clip-on Zipster - John Jason Fallows

This is a special pellet shooter (technically a rubber band Zipster) that I finally figured out which I spent about 1-3 years trying to perfect and I finally mastered the best way to have a belt pellet shooter

this is based on the rubber band pellet slinger by popular demand but with a new twist and that is it clips onto your pants & is something easier to carry and is a good back up to the slingshot being carried

*INSTRUCTIONS BELOW

How to operate get a rubber band long enough to easily fit through the prongs and past the tube then you want to use the tube as a handgrip then get a pellet or other projectile with your thumb against your hand from the rear side but aimed towards the front then and when ready to shoot let go. it is a good idea to shoot properly to ensure proper safety which includes to avoid accidently shooting yourself have a proper alignment , proper posture & a proper grip & thats safety which brings me to my next point

(DISCLAIMER)

Responsible owners only, at your own risk for any liabilities, check your local laws before downloading, 3dprinting, carrying transporting, or traveling with these. If you break the law then your at fault not anyone else if you do not have the capacity for that and safe handling then your not mature enough to have one also

. This is meant for recreational use only unless your protecting yourself during an emergency if legal.

Also, this is for non-commercial use do not reupload the design code for others to share without permission as of the policy of the designer with an exception for 3dprinting services to make the part for you as long as their not reselling also credit where do, any further licenses outside of authorized pages are prior art , if you see someone plagurising or stealing please report them by send me a tweet or message @TimPatAlPostma on twitter

tough pla will work but i used Filaments.ca’s PC CPE
it can print in under 3 to 4 hours but can be printed in 2 & 1/2 hours , it is under 135.72 x 110.5 x 37.18 mm

Beware of watching your hands and fingers & keep your little finger under the launcher & I recommend x2 size 64 rubber bands that are slip knotted & with pellets from the pellet pack

(Keep in mind this is experimental so far so at your own risk)

It can also double up with the slingshot

This article was first featured at https://cults3d.com/en/3d-model/various/clip-on-zipster on July 12, 2020 at 04:23PM by