Snap on mid print filament runout sensor holder box

Tinkercad:
https://www.tinkercad.com/things/lbXKMSh7Mdl

This is designed for rwmech / maker mashup’s runout anywhere wifi filament runout sensor found here:
https://www.youtube.com/watch?v=dn2Pl7ypKQ4

I have not printed and tried this yet. If someone else does, please post a make / comment.

This is designed to snap on, or screw on if you want it to be permanently closed. Took the snaps from another design and added them to the box, then added a cutout for where the filament is fed through, and a block to the lid to hold the filament in place against the sensor.

Note: this will require you to glue down the sensor / hold it down. I did that in my original one anyway with a 3d printing pen, but glue or tape should work.