ender 3 pro filament guide – simple and clean

https://www.tinkercad.com/things/jx382TJcW1U

I liked FlintWeiss’s design (one screw, stock hardware, etc) but I thought the hook caused a pretty harsh angle on the filament. Also, I used that design and it broke after a while (likely my fault in printing).

I also liked Seba’s design, but I didn’t need the clip as I have some drag chains holding the wires in place. Also, I didn’t want to remove both screws to put it in place, as I leave them a little loose to prevent binding on the z screw that the Ender 3 pro is prone to. With the one screw design, I could tighten the screw on the left that holds the guide on, and leave the right screw slightly loose.

The one downside to this print is the required supports. S3d file, fff profile, and support picture attached.