RC Factory Edge 540 V3 lipo try

So this is my first design,print and upload. Im new to 3d printing and wanted to come up with something that i could perminatley fix to the foam to give it a little strength when taking lipo on and off.

V1 was a solid 6mm

V2 4mm had a piece taken out the middle to save a little weight

V3 4mm had a cut out to allow plate to go over white landing gearfixing.

All 3 have a cut out to allow a velcro strap to be placed under to secure lipo.

Hope this is of us to someone?

To print i flipped it upside down 180 deg