MaskUp-Initiative

We are a Non-Profit-Initiative and our goal is to provide equipment where it is currently needed the most in order to prevent Covid19-infections.

You own a 3D-printer and want to print faceshield for your own use?

+++++++++++++++commercial use is strictly forbidden++++++++++++++++++

Needed prefabricated parts:

1 mount

1 clip

1 elastic rubber band (width at least 10mm/0,4“, length ca.30cm/12“)

1 overhead transparency sheet with rounded edges (thickness ca. 0,1mm/0,0039“)

Needed tools:

cutter knife

sand paper

scissors

Here you can purchase the needed materials*:

Overhead transparency:

https://amzn.to/3bV9QwB
https://amzn.to/34aJjbI

Rubber band:

https://amzn.to/39JYM3E
https://amzn.to/3aKnemP

3D-Printing filament:

https://amzn.to/2X8bPcL
https://amzn.to/39HeP2g

3D-Printing

Recommendation 3D-printing settings:

Each printer has his specific settings, so normally each single person

know in detail which settings are the best to get a good result.

Wall number: 3

Layerhight: max. = 0,3 mm / 0,11811″

Infill: min. = 20% up to max. = 100% (the parts showing less Infill)

Speed: start slow with 40 mm/s and rise up until max. 100 mm/s

Used 3D-Printer*:

Creality CR 10 V2
https://amzn.to/39Lq3CZ

Disinfect before use.

This is no medical prouct.

It is no official licensed product.

Developed following DIN EN 166

Use at your own risk.

No liability is accepted.

*With these Affiliate Links you support the MaskUp Initiative for free.

This article was first featured at https://ift.tt/3aFNVZY on April 5, 2020 at 07:51AM by saoe