Rear sight mounted Picatinny rail for and AIRSOFT AK47 / AKM

This is a Picatinny rail for and AIRSOFT AK47 / AKM / What have you.

Mine is mounted and modeled after the CYMA CM.048S, but it might fit other makes and models.

If you want to measure before the printing, then my rear sight is 12mm wide and 3mm thick.

The rail is 2″, or about 55 mm.

I recommend printing it at a 135° angle, as illustrated in one of the pictures above.

As such, mine prints with brim and no supports.

I couldn’t find any Picatinny rails mounting on the rear sight block for the AKM/AK47, so I drew up this one.

It replaces the rear sight slide as can be seen in the pictures. It is a friction fit.

The mounted optic can feel loose-fitting, but that is simply the rear sight itself.

From what I can see, it keeps it’s zero after it springs back into position after having been pushed.

THIS IS NOT DESIGNED, INTENDED, OR RECOMMENDED FOR USE ON A REAL FIREARM – FOR AIRSOFT USE ONLY

Please do not use this for profit! Giving one to your 3D-printerless friend for a buck or a favor is fine, but do not start a production line, thanks!

Feel free to give feedback!

Thanks again!