MYNT3D Printing Pen Stand

Was looking for a good stand for my Amazon MYNT3D Printing Pen that left the nozzle open if it was still hot and figure why start from scratch and just remixed thatdude902’s stand. It should put the nozzle about 8mm or so off the surface and only the bigger of the 3 vents on the sizes of the nozzle is covered. I haven’t tested how it will react to the heat printed in PLA just yet, but the fit is good.

I added a second version at a 45 degree angle if straight up and down doesnt work as well for you (although I havent personally printed it yet.)

I used PLA, but obviously PETG/ABS would be better. Printed at .3 for a faster print with supports for the center square.