E3D Bowden Mount for Creative3D Elf

Hi everybody.

I have remixed an E3D mount for the Sapphire Pro created by “Fvrank” to fit the Creative3D Elf. You will lose approx 12mm of build area in the Y axis (couldn’t be helped unfortunately). This E3D mount incorporates both square fans from the factory set-up, and I have included new fan ducts to fit (some E3D clones are taller than others so you may need to alter the ducts to fit, using Tinkercad or whatever Cad program you prefer) and a replacement Y endstop mount which you NEED to stop the hot-end from smashing into the frame. I have also included photos of part-printing orientation, support placement, and others. I suggest printing everything in PETG since it is a hot-end mount (my tester in the photos is PLA which will work for a while but the heat might warp the fan ducts eventually), 0.20 layer height, with 100% infill, and supports where indicated.

I hope you enjoy this E3D mount !!