Hypercube Titan Aero Mount with DC42 Mini IR & Rear laydown radial fan

My previous design limited Y travel from the front fan hitting the extrusion and my led lights in the front of the printer, so I remixed the already amazing mount by Asphyth to work with my mini IR sensor from David Crocker. The offset of the sensor is 27mm to the left of the hole of the nozzle and the pcb is 2.385 mm below the tip of the nozzle (this may very due to slight slop in bolt holes for clearance so make sure you follow set up guides.

This is a work in progress as I am printing it, once I have it complete and tested I will update the page.

I have included the Fusion 360 files as well as the STL for my X carriage that uses a 22pin Molex connector so the hotend can be removed easily without unwiring anything, just unplug 1 plug and it comes off (with rear fan you can add 2nd plug just for that fan so you can leave fan set up on x carriage and just remove hotend)

I also included the cover I made for the DC42 Mini IR, this isn’t needed but it will help keep filament off of sensor if there is ever a runaway print

I used tiny dupont connectors like E3D uses on the fans, heater, and thermistor so if I ever have to change one I can use big plug to get hotend off printer and then simply unplug the item I want to swap out and plug in the new one