Surface Mount Hinge 90-Degrees

90-Degree Surface Mount Hinge Version 2

Only need to download 1 Articulating Hinge File, the “reductionofOverhang” version is just so the hinge is printed in a more collapsed state

This is a concealed hinge with full overlay. It opens up to ~100 Degree Angle

The hinge provides a nice seamless look to the door when closed.

I printed the hinges at 30 mm/s, I haven’t experimented with higher speeds.

Wall Line Count: 3 (Anything less will make hinge weaker)

Top Layers: 3

Bottom Layers: 3

A single hinge can hold 10lbs @ 4″ away from base of hinge.

I haven’t tested any heavier, so do so at your own risk.

I have videos of the tests on my instagram.

Insta: 3dprintingwithausten

May be obvious but make sure to use 2-3 hinges when mounting doors to eliminate deflection so the door closes properly.

Reference attached photo for installation orientation.

I used pieces of filament for the pins to connect the two bases. I found that it works perfectly fine. If enough people want to use actual metal pins, I can include a model that incorporates metal pins.

The base uses 8 x 4mm screws.

NOTE: Future update may include a self-closing function that can be printed**